Grinding Ball Mill is usually used in mining, construction, and other industries which need fine powder producing. In this article let's talk about the operation flow of Grinding Ball Mill:
1,check the mechanical and electrical parts before driving, check if the connection bolts are loose; the lubrication point of lubrication is normal, the transmission is normal and reliable, protective devices intact, electrical instrument is sensitive, good contact with the motor brush.
2,wheel it for a week, check the equipment rotating around and make sure it without obstructions, and eliminate. No standing around the station when starting.
3,after inspection, press the start button to start the motor, pay attention to current changes. Ball mill can be continuously started for no more than twice. If the start it thirdly, it must be checked with the electrician, fitter before starting. Do not start with other devices at the same time, to start staggered to avoid tripping.
4,after the normal operation of the mill, it is necessary to observe the provisions of adding water, mine and steel balls, prohibit overload operation, idle time is no more than 15 minutes, so as not to break the liner.
5,in the operation of the cylinder should pay attention to check if the cylinder is leak pulp, carefully observe the current, voltage, feed, water supply. Every half an hour to check the motor and the spindle temperature which should be lower than 60°С, to find the problem in time.
6, during the operation you should pay attention to observe if the hollow shaft, the oil ring is rotating with oil, hollow shaft temperature is normal, if the hollow shaft heat, close to burning tile, it should immediately take forced cooling measures, without immediate stopping, so as not to cause "axle". At the same time pay attention to check the lubricating parts, temperature of oil, with regular fuel.
7, the ball mill should be stopped after feeding, after the treatment of concentrate within the stand, stop the water supply.
8, in the absence of notification of power outages, you should first pull down the knife, press the stop button to stop the mine, water supply.
9, after the shutdown, clean up equipment and environmental health, to ensure civilized production.
This is the operation flow of Grinding Ball Mill, if you do as it, i believe your ball mill will have a long service life which makes you satisfied.
