The skills of prolonging the service life of micro powder mi

A lot of grinding equipment, micro powder equipment will appear kinds of equipment problems after using period of time,some of these problems will not avoid , but some really can avoid, now Clirik tells you how to avoid the problem  to better use it and make its equipment safe and efficient operation down: first, there should have fixed person responsible for custody during the micro powder mill works, and the operator must have the technical level, the person must conduct technical training before the grinding installation to understand the principle of grinding machine performance, familiar with the operation procedures.To make sure the grinding machine work normally,we shall develop equipment "maintenance safety operation system",ti can guarantee the safe operation of the long-term grinding machine, and have the necessary maintenance tools and the grease fittings.After grinding machine use for a period of time, we should carry on the overhaul, at the same time replacement or repair the grinding roll grinding ring shovel knife of vulnerable, careful examination shall be done to the grinding device in the use of connection bolts, nuts, plug before and after, if there's any loose phenomenon, add the lubricating grease whether. The grinding device use more than 500 hours to replace the grinding, the roller set inside each of the rolling bearing must be cleaned, the damaged parts should be replaced, refueling tools can be used manual manual gasoline or butter gun.