How to alter the wearing parts?
1.Remove the two repaired bolts (as 1) around the best of shaft.
2. get rid of the nut (as 2) around the best of shaft (in counterclockwise direction).
3.Remove the upper distribute plate (in counterclockwise direction). It are heading to be less difficult to get rid of the distribute plate if set some oils to the screw threads, and set a item of steelbar with diameterφ30 into 1 of 4 (diameterφ32) holes around the plate, then strike the steelbar in clockwise path to get rid of the upper distribute plate).
4. get rid of turn plates 4&5
Screw 3 M24 eyebolts to the holes around the upper turn plate, then strike the plate lightly with a hammer, get rid of it use lifting appliance, right after finished, use identical method to consider out the reduce trun plate.
5. get rid of 7 shafts.
6. alter the putting on parts, along the lines of rollers, rings, etc., then assembly the elements back.
